FramePkg
  • Home
  • About
  • Procedures
    • ePO Upgrade
    • ePO Architecture
    • BackUp ePO
    • How To Uninstall McAfee Client Manually
    • McAfee Drive Encryption
    • TIE Guide - A to Z Steps
  • ePO
  • VSE
  • DLP
  • HIPS
  • Solutions
  • Tips
  • Videos
  • Online Updates

improve performance - Solidcore / Application control

17/8/2017

1 Comment

 
To improve performance, disable the inventory rollback feature as follows:
1.            Launch the command line interface for Solidifier.
2.            Run the following command: 

​sadmin config set IsInvbackupEnabled=0

​This feature is enabled by default and creates a backup copy of the local white-list, so if the white-list corrupts, MACC can recover it from a backup copy immediately rather than be forced to re-solidify the system. This backup copy is created during the boot sequence, which increases system boot time and cause Performance issue which we are investigating but as workaround we recommend to disable it.

If the command is run through ePO using task “run command”, then check the request response and the output of this will be seen under

Menu-> Solidcore client task log -> 
And if done locally, then check under “sadmin config show -d” output

Reboot is not required.

1 Comment
    Picture
    View my profile on LinkedIn

    Categories

    All

    Ebates Coupons and Cash Back

    Archives

    August 2017
    March 2017
    October 2016
    June 2016
    March 2016
    February 2016
    January 2016
    December 2015
    May 2015
    March 2015

    Buy me a coffee:)